Instructions for the use of Quick-mix colored masonry mortar

The Company Quick-mix produces dry masonry mortars for masonry and facing clinker bricks, which are ready for application after addition of water.

 VM01T  VKPlus

These masonry mixture does not require the addition of any additives other than water. The dry mixture comprising inorganic pigments, resistant to weathering

On brick properties masonry mixture are:. For strongly absorbing bricks with water absorption of more than 10%(masonry VK PlusT solution), for bricks with moderate water absorption of up to 8%( VM 01T solution masonry) brick and low water absorption to 5%(mortar VZ 01T).

HOW TO USE READY masonry mortar QUICK-MIX

The contents of the bag (25 kg) mix with approx. 3 liters of water. The amount of water depends on the weather! The mixed solution to be used for laying for 1 hour without addition of water. The addition of water during use of the finished mixture may change the color of the solution. It is necessary to carefully stir the solution. NOT permissible to add any additives, t. K. Additive may cause degradation

properties of the finished mixture. The solution was applied in an amount such that after compressing brick solution acted as a bit in the horizontal and the vertical seams. Excess solution to remove trowel.

Grouting should be performed only when the solution is sufficiently harden. The moment of performance is determined by pointing "finger test." If the solution rubs a finger, wait. Once the solution has ceased to smear finger-you can begin to unravel. Grouting is performed using a special jointing spoon or via a curved tube of suitable diameter. Grouting is necessary to produce the same degree of hardness of the weld.

Fresh masonry to be protected from direct sunlight, from high winds, rain and frost.

unacceptable performance masonry at a temperature below 5 and above 25 degrees!

WARNING!

Masonry cement mixture comprises water and adding the alkaline environment is created. In contact with skin and eyes rinse thoroughly with running water and consult a doctor

THE BASIC RULES OF MASONRY ON SOLUTIONS QUICK-MIX !

Store bags masonry mixture in dry

Use mortar corresponding coefficient of water absorption of bricks

Add the dry blend is always a certain amount of water

A well-stirred solution

. The finished solution is not adding anything

! grouting to start at a certain moment-"finger test"

After the completion of the work lay laying

Do not perform masonry in the rain, cold, heat.

Product added to wishlist
Product added to compare.