oil separator (carbohydrates) retards oil (carbohydrates) and sedimentary substances contained in the wastewater. Very important is the correct choice of equipment for a particular object. The separator may not be too small because it does not provide the desired separation, it may also not be large - for purely economic reasons. Koalistsentnye separators and sump system "By-Pass" SWOBK (SW- oil separator; O-settler; B-system "By-Pass-5"; K- koalistsentnaya cassette;) are different productivity - 3 l / s to 20 . l / s, while the system "By-Pass, productivity increases to 100 l / s
OPERATING PRINCIPLE KOALISTSENTNOGO SEPARATOR oil from sump aND BY-PASS:. Rain and as technical water containing petroleum and other solid contamination (dirt, sand and other solids) in the first step fall in the sump, which is intended to separate suspended solids (soil, sand, etc.) from the waste water, as well as to easily delay . separable part oil sump serves as a soothing and averaging vessel BY-PASS (overflow (overflow) bypassing) mounted in the sump above the input threshold of the separator -. this system the use of which can fivefold increase the nominal flow rate (a standard solution) separators. ry system "By-Pass" used to drain storm water from large areas. BY-PASS provides the separator operation during heavy rains. When it rains heavily volume entering the separator stormwater exceeds its nominal raskhod.Esli this level is exceeded, then switched BY-PASS. Thus, excess liquid has little oil content and does not disturb the operation of the separator, and simultaneously the mud, sand and dr.tverdye substance retained in the sump. With the integrated deceleration and speed deflector sedimentizatsii process is cleaned from the solid impurities contained in the wastewater. In the next phase of water contaminated oil enters the separator, which is equipped koalistsentnoy insert - is an integral part of the separator, its structure similar to a honeycomb structure. Each drop contaminated water must pass through the labyrinth insert, curved walls. During passage through the liner minute particles of petroleum products that are in the water adhere to the walls of the cells, as the core for the formation of larger droplets. A drop reaches a size in which sufficient energy to detach it from the wall, causing it and rises to the surface. Wastewater is discharged from the separator through a siphon provided with an automatic gate, which prevents the penetration of oil to the outside. Oil form a layer which accumulates in the separator and the purified water to the required metrics may output to the environment. Oil separators are made of high density polyethylene, in accordance with standard PN EN 1825-2: 2002 (U) corresponds to the international quality certificate ISO 9001 and has the following properties: good resistance to impact, great views inner and outer surfaces, resistance to ultraviolet radiation . The main separator equipment:
- sump; - a separation chamber; - koalistsentnaya cassette; - System BY-PASS (increases the capacity of 5 times). - automatic system of blockade; - sampling system; - ventilation. Optional: extension, iron hatches (withstand up to 15 tons) system, visual and audible alarm. Note: On special request, the separator can be equipped with extended bypass, which allows ten-fold increase the nominal flow rate, as well as manufactured separators settlers double and triple stock cameras for a pump and a fiberglass body, depending on the requirements your object.
